Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone i have a cisco pix 506 directly attached to a cable modem, and a cisco 2621 attached to the other side leading it into the networkmy main problem is when i use my vpn client to connect to work it will not connect, and the error details...
Hello everyone i have a cisco pix 506 directly attached to a cable modem, and a cisco 2621 attached to the other side leading it into the network<2950>--<2621>--|pix 506|--<Cable Modem>--<Internet>syslog attached with error detailsrouter config attac...
All,I am currently running a definity system with unity mail the definity is currently G3V4 and the unity is 3.1 build 3.1(5), we are going to be upgrading the definity to version R11. The two are linked using PBX Link. My question is... are we going...
I am having some trouble connecting the two with isdn you will find floating interface routes for the isdn. when running debug I get on the WHSE-TO-MAIN Router "cause I =no route to network", and on MAIN-TO-WHSE i get "cause i = host rejected"any th...
Let me ask you a question im using both ip unnumbed on the S0 interface, and the Dialer1 interface. Is this going to cause any problems, as you can see in the diagram im not done configuring it for backup, right now im just trying to get it to work. ...
OK i have found out from previous posts that this version of Cisco IOS Cisco IOS Version 12.0(9) does not support dynamicly assigned IP's, so i will not be able to use this IOS to support my ISP, my router type is cisco 1605. My question is what ver...
1. Version 12.0(3)T2. Dynamic IP, but i do recall specifying the ip, and it still working.3. No PPPOE Required4. as far as the configureation i have specified one internal address of 192.168.1.1 255.255.255.0, one extenal address of the isp.hostname ...
