Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all , I am a little confused about the specs. The AS5350 will allow 210 concurrent calls - but there is a max of 108 DSP´s. In what situations would a call not use the DSP´s ? Would an IP to IP call use a DSP ?
Hi all , I run an AS5350 gateway which is connected to our pstn switch . A customer of ours has 2 call manager´s , we provide the PSTN connection. The customer is working on connecting 3rd party H323 CPE (allied telesyn) with his CCM net. If we call...
Hi allWe are a service provider with AS5350 GW. Our customer has cisco call managers and wishes to use our AS5350 as gateway to the PSTN. He wishes to use MGCP. It´s not entirely clear whether it can be done or not - I mean , both support MGCP , but ...
I have an AS5350 and am using 827-4V endpoints. The endpoints have their 4 FXS ports connected to analogue CO cards in small PBX´s. Port 1 has the company main number , ports 2 , 3 and 4 have other numbers. The problem is that if a call to the main...
Hi all , We can send faxes from the 827-4V endpoints out to remote PSTN connected fax , but we cannot receive at the 827-4V´s -- handshaking occurs between faxes but the call always drops and no fax data gets through. I have run "debug vtsp sessi...
Thanks Chester , I now understand the architecture after reading the online document "Understanding NextPort SPE Versions" .My NP-108 card has 18 SPE´s , each holding 3 DSP´s. One DSP can handle two calls. Total = 108 ports. My 3 slot AS5350 will not...
"Each DSP can do 2 calls at once, that is whay the numbers are this way." Thank you Chester , that information is hard to come by. I didnt find any such information at all during my searches ! Only that the AS5350 has a max of 108 ports . Have also ...
Thanks for your reply Eyabane , you are right about my mistake - it was meant to be CCM2 in that paragraph. To answer your pointers :1, I have been assured that the config and version etc are identical on both CCM´s.2, I´ll have to check with the cus...
It works just fine - thanks jcmartin , you made my day.One other thing I learned - if you dont do the "no gateway" command on the 827-4V before changing the config - it will crash and reload clean !! . Have a good weekend.
