Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I will be implementing transit to multiple internation ISP soon and now looking for design best practise in terms of the BGP routing control. Hope someone have the url or good documentation on this matter.Thx in advance.
When I shutdown the primary ACS service, the authentication and accounting take a long time to process. Is it normal? Whenever new command is enter, it take sometime to display after the command authorization. The time toke almost the same as timeout...
I have routers configured with 2 bvi interfaces for dlsw.When I configure NAS setting with 2 ip address, sometime the AAA authentication failed to prompt for user authentication.Should I used ip tacacs source-interface?If I configure only one, if tha...
After restoring the backup copy of the database on ACS SE 4.1 with user and system setting, eap type not configure exist in failed attemp log.Will it be the backup database does not backup the private key which I used for peap-gtc? Which make all my ...
Hi,Thx for the information. In terms of transit AS, are there any ways to verify whether my environment become a transit AS?The normal practice is to received routes from direct peer with ^$, and the direct peer customer routes ^123_ and peer's route...
Hi JG,It's production unit where I can access using GUI.When I reboot the ACS SE, I can see the bootup message from the console using 115200.After fully boot up, the console port cannot be access even though I can the baud rate to all other setting.
Hi,Is there any documentation listed down all the process running on switches which tight to what services enable?Some of the process can be easily identify but not all?Regards,
I would like to know what do you mean by mac address flipping?When refering to filter, does it mean MAC address filtering and input/output lsap filter? I did try using output-lsap-list the result quite consistent where my client (connected at access ...
