Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a router 1721 with three interfaces.- FastEthernet0 is LAN.- Ethernet0 is WAN and is connected to provider1.- Ethernet1 is WAN and is connected to provider2.The two providers are up and they are routing traffic without problems.I have to...
Hello,I have two CSS11501 cofigured to load balance and both connected to the same switch.The CSS are configured for VRRP to share a virtual IP on each interface.The problem is that both CSS are showing the mac-address of the Virtual IP, so the switc...
Hi all,I have the following router 7500:sh verCisco Internetwork Operating System Software IOS (tm) RSP Software (RSP-ISV-M), Version 12.0(9), RELEASE SOFTWARE (fc1)Copyright (c) 1986-2000 by cisco Systems, Inc.Compiled Mon 24-Jan-00 22:58 by bettylI...
Hi,I have a router cisco 3745 without networks modules.I need to connect to this router a lot of E1 (structured or not structured) and I need to know what is the best option in order to connect those E1 to the router.I am wondering if "NM-8A/S" is a ...
Hi,Thanks a lof for your help.My problem is that, just due to the great quantity of E1 that I must connect to the router, I need cards with which I don't need utr (CSU/DSU).I have been reading about NM-2CE1T1-PRI card (in order to connect four this c...
