Hi there,
I encountered a strange problem today with OWE in transition mode.Suddenly a handfull of users could not see the OPEN SSID at all. But when they moved to another section of the office they got the OPEN SSID and were able to connect. After t...
Doing LAN automation with intermediate nodes already set up is fully supported, the only requirement is that the ports on the intermediate node towards the to be edge nodes are layer 2 and that the LAN Automation IP pool is distibuted into ISIS on th...
No problem.
When you say fabric sites (plural), do you mean with separate border/control nodes for each fabric site, or one distirbuted fabric site? Keep in mind that you can only have one WLC manage one fabric site, not multiple.
Mix mode is sort of...
The DHCP servers under network settings is just made available for you to select during IP scope creation. No config to my knowledge is pushed to your switches and WLC if you just add DHCP servers to network settings.
DNS under network settings gets ...
You can just push it without issues. Its not an error message, just a warning that you are applying CLIs to something that DNA Center interacts with during network intent.
As for your other questions. This is the golden rule i follow when creating te...
When you do the L3 handoff on a switch the catalyst center will add the link networks for the layer 3 outs as SVIs.
Just convert the interface to L2 trunk and move the ip address on the switch to an SVI in global. Add .1q tag on a subinterface on the...
