Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have implemented WCCP between Cisco router and Bluecoat cache engine, there's a ASA placed in between so we have configured the firewall to allow ports (UDP 2048, & GRE) in order for the WCCP sessions to be established. The WCCP sessions is being ...
We have got a CE500 switch that connected to our backbone switch (2950), we've configured the gigabit port as trunk on native vlan and created two different vlans (vlan21 assigned to port1 and vlan22 assigned to port2. now the trunk port is able to c...
Hello All,currently we are in the processing of requesting an ATM link with our carrier provider, we have been told that our inteface should be ATM UNI 4.0 standard and the interface must be G.703Appreciate if someone can help in what should be the p...
Hello All,I’m just wondering Cisco recommends a specific router based on the bandwidth requirements as we’re having 2611 router with 64 DRAM and 8 Flash, currently is handling 3 Mb of internet bandwidth and we’re planning to upgrade to 5 Mb, I want t...
Geanelmen,We have configured traffic shaping on our router for limiting internet traffic for our customers:interface FastEthernet0/0.11 encapsulation dot1Q 11 ip address x.x.x.x x.x.x.x traffic-shape rate 256000 7936 7936 1000after checking the band...
The users and cache engine NOT connected on the same interface, the users & ASA connected on separate physical interfaces of the router and the cache engine is connected to the ASA, looks like below drawing,Users||Router ---> ASA ---> Cache Engine||I...
For the outgoing traffic you can assign a higher weight for the default route that received from ISP that connected on OC-12, then all the outgoing traffic will be going through this interface
Problem solved.the problem was with the vlan22 as it was not created on the backbone switch, only vlan21. so i've created vlan22 and everything works fine...Thanks all for your help...
the CE500 can be configured through GUI only (no telnet/CLI). so i've configured the smartport role as switch for the gigabit interface and on the port status tab i can see the port is configured as trunk but there's no space to allow the trunk to ca...
I'm also looking for MPLS book to get started with the basic and as i advised i will be starting with "MPLS and VPN architecture Vol 1"Omar,I would appreciate if you can forward me the pdf copy on my email abaghir@gmail.comThank you,
