angelyouyou
Beginner
Beginner
Member since ‎11-02-2017
‎01-02-2024

User Statistics

  • 23 Posts
  • 1 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies
1 Accepted Solution

User Activity

Software version and topology description (see topology below):1. As shown in the topology in the attachment below, the attachment contains the configuration file of the P device (P-configuration.txt). In the topology, Cisco7206 15.2(4)M11 version so...
软件版本和拓扑说明(参见附件MPLS-Aware-NetFlow.png):1、如下附件中拓扑所示,附件中包含了P设备的配置文件(P-configuration.txt)。拓扑中使用Cisco7206 15.2(4)M11版本的软件运行BGP MPLS  L3VPN(公网隧道协议为LDP); 2、CE1上的IP地4.4.4.4和CE2上的IP地址5.5.5.5可以通过MPLS L3VPN正常互访;3、在P设备的g1/0接口开启NetFlow采集(入向和出向),开启NetFlow V9并将NetF...
I'm using Cisco ISO 7200 (15.2M11) release product. When I enable SNMP, I cannot get the SNMP information of the device through the IPv6 global address, but I can get the device information through SNMP normally through the IPv4 address. Check the li...
As shown in the network topology above.Regarding NetFlow FNF, I created 2 flow-records (1 each for IPv4 and IPv6), 2 flow-exporters (1 each for IPv4 and IPv6), 2 flow-monitors (1 each for IPv4 and IPv6), and then The g1/0 interface is bound with a to...
  如上面的网络拓扑所示。关于NetFlow FNF,我创建了2个flow-record(IPv4和IPv6各1个)、2个flow-exporter(IPv4和IPv6各1个)、2个flow-monitor(IPv4和IPv6各1个),然后在g1/0接口上绑定了出入方向、IPv4/IPv6共计4条Flow导出配置,配置如下(附件中也上传了配置文件和NetFlow抓包文件)。但是当我在R2设备上ping R1下挂的PC机IPv6地址(2003::F043:5531:E4AB:8A33)尝试让R1导...
Community Statistics
Member Since ‎11-02-2017 10:14 PM
Date Last Visited ‎01-02-2024 04:24 AM
Posts 23