Looking to tunnel between two routers however i cannot use IP addresses at all for either source or destination. Currently i have the source set to fa0/1 to combat this however i cannot set the destination ip at all. this also occurs with hostnames i...
Doing some coursework for university. My learning materials seem to suggest that IPSec integration is standard with IPv6.
However if i use "show cry ipsec sa"
It says there is no SA's available.
If so should i begin the instructions provided here...
Hi, Ive just completed a cisco lab and did as instructed. When i ping outside the subnet it says
"Destination host unreachable."
As far as I can tell its supposed to do this. Is there a way to get it to do so?
I've attached my file bellow.
This ...
Set up two dummy networks so that i can use them in my coursework for testing however i cannot get the two to communicate currently. They are set up with ipv6.
These are the commands ive used. Thanks in advance
R0(config)#interface fastethernet0/0 ...
