Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, The cisco c9105AXI-E is a controller based AP while the 9105AXi-EWC-E has an embedded wireless controller. Does the 9800 WLC require software subscription/license for each AP connected to it and does 9105AXi-EWC or any other embedded wireless ...
Hello, What are the possible methods of deploying a Cisco 3602i AirCap Access Point and Cisco c9105AXi AP without an external Wireless LAN Controller?Is it possible to deploy the 3602i access point in lightweight mode, using the inbuilt AireOS Wirele...
Hello, WAP371 devices refused to allow the inclusion of a device's MAC address in the list of allowed MAC addressed when configuring MAC address filtering. The weird error message is attached. It says: "The MAC address cannot be a multicast or a broa...
Hi Everyone,
I've a Cisco Switch running IOS 12.4 but it seems impossible to configure an ACL to restrict access to a particular IP outside the network i.e. on the internet.
When I used "deny ip" or "deny tcp" and applied "IN" ACL group on the in...
Hi Everyone,
I've a Cisco router running IOS 12.4 but it seems impossible to configure an ACL to restrict access to a particular IP outside the network i.e. on the internet.
When I used "deny ip" or "deny tcp" and applied "IN" acl group on the in...
The document is a bit ambiguous as to whether c9105AXI-x is EWC-capable. Obviously, c9105AXI-EWC-x is EWC capable. https://www.cisco.com/c/en/us/td/docs/wireless/controller/ewc/17-5/rel-notes/ewc-rn-17-5-x.html It seems the ONLY method of deploying c...
Also, is it possible to upgrade the c9105axi-e IOS from lightweight mode, which is the default, to ewc IOS in order to enable the use of the device without an additional appliance/WLC? Thanks.
There are other supported wireless controllers for c9105AXI-E as shown below: supported wireless LAN controllers: Cisco Catalyst 9800 Series Wireless ControllersCisco 3504, 5520, and 8540 Wireless Controllers and Cisco Virtual Wireless Controller W...
Please share the link for the current image (ap3g2-k9w7-tar.153-3.JF14i.tar) released in March, if you have it. You may share via google drive or wetransfer. Thanks.
@Sandeep Choudhary, it means the only way to deploy 3602i without an external WLC is in autonomous mode. But why is the default mode lightweight because it would have been easier to deploy without an additional appliance in autonomous mode? Thanks.
