Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
helo all, I am currently installing Cisco wireless IPS (WIPS), which is the WIPS are integrated with Cisco Prime and WLC. The installation already done and i try to prove the feature of WIPS that can prevent Rogue AP. I'am using Honeypot that running...
hi allwe have dual homed internet in our Internet Edge firewall (firepower FTD FDM 6.2.3).both of them running NAT publishing for different application, for example : application A (segment 0) and application B (segment 9), application A using nat vi...
I already done the SSL VPN Remote Access setup, and user already can connect to inside network and access the internet following the company network (I dont use split tunnel for that connectivity). i enable the NAT Exempt and inside interface all in...
i have 2 box cisco 3850 with same series and same software version (typical), these switch operating in stack switching mode.
i plug some SFP module in both of them, but when i take look in show inventory command, i see the SFP module only detected i...
I Try to make layer 3 Port channel in 3850-48T switch, but i found error like this :
DRC-INSP-SWT-01(config-if)#inter ra g1/0/45-48DRC-INSP-SWT-01(config-if-range)#no switchportDRC-INSP-SWT-01(config-if-range)#channel-group 1 mode activeCommand rejec...
hi patoberli, thanks for reply.1. rogue containment policy based on rogue rule, contain malicous rogue ap detected with the same SSID2. no we dont have, in the testing room we just deploy 1 monitor mode ap 4800 series aironet and honeypot ap (running...
thanks paul for the reply.
i've solve the problem. it think its right to do this step :
1. create manually the PC interface and make it as layer 3 interface
2. enter the group of physical interface and make them layer 3 interface also
3. bundled the ...