Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi this is the configuration of my router 2801:version 12.3 service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname XXXXXX ! boot-start-marker boot system flash:c2801-spservicesk9-mz.123-14.T...
Hi,i've a problem,in my dial-peer XXX voip i've configured the DTMF-Relay, so the incoming digit will be relayed by the voice gateway, but on the outbound calls, there is no possibility to configure the dtmf-relay so when i call an ivr my digits are ...
Hi,i've configured IPCC express standard as IVR, so all the incoming calls are redirected on the IPCC number. This ivr answer the call and redirect it based on the number pressed from the caller.Is it possible that any incoming call will be managed b...
Hi,i've a router 2801 with the card VIC2-2BRI, i've this problem:when i plug-in in ISDN cable on the BRI interface the interface BRI doesn't change the state to up, it seems that the cable is not connected.I need to reboot my router with the ISDN cab...
Hi,i configured my ipcc express to answer on ext 9003,but i don't know how to configure my voige gateway dial-peer to forward all the incoming calls to the 9003 IPCC.Anybody have an idea?My voice gateway is a cisco 2801 and comunicate with callmanage...
Under callmanager administration web page:Service --> Service Parameter --> CallManager Parameter.change the value of: T302 Timer (msec)* change it to 7000 or less if u need. This will reduce the delay before starting the call.
The IVR is an external systems, for example when i call the McAfee company there is an IVR the aswer the call.My router is connected to Telecom with an ISDN Bri.So i need the dtmf relay for the outbound calls.I've configured this:mgcp dtmf-relay voip...
