04-04-2006 01:38 AM - edited 03-13-2019 12:45 PM
Hi,
i've a problem,
in my dial-peer XXX voip i've configured the DTMF-Relay, so the incoming digit will be relayed by the voice gateway, but on the outbound calls, there is no possibility to configure the dtmf-relay so when i call an ivr my digits are not relayed by the router....how can i configure this parameter for outbound calls?
P.S. I'm using MGCP between voice gateway and callmanager 4.1(3)
BR,
Claudio
04-05-2006 12:30 PM
How is the gateway connected to the IVR? Is it using FXS/FXO or T1 lines? If yes, then you don't need dtmf-relay for outbound calls as the dtmf-relay applies only to the VoIP side of the call.
Also since you are using MGCP, you need to use the following command for DTMF relay on the VoIP side
mgcp dtmf-relay voip codec all mode cisco
Regards,
Anup
04-07-2006 04:43 AM
The IVR is an external systems, for example when i call the McAfee company there is an IVR the aswer the call.
My router is connected to Telecom with an ISDN Bri.
So i need the dtmf relay for the outbound calls.
I've configured this:
mgcp dtmf-relay voip codec all mode cisco
in my router, but it seems, it doesn't works.
This is my router configuration:
version 12.3
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname XXXXXX
!
boot-start-marker
boot system flash:c2801-spservicesk9-mz.123-14.T6.bin
boot-end-marker
!
logging buffered 51200 warnings
!
aaa new-model
!
!
aaa authentication login default group radius local
!
aaa session-id common
!
resource policy
!
clock timezone Milano 2
clock summer-time CET recurring
network-clock-participate wic 3
network-clock-select 1 BRI0/3/0
mmi polling-interval 60
no mmi auto-configure
no mmi pvc
mmi snmp-timeout 180
ip subnet-zero
ip cef
!
!
no ip dhcp use vrf connected
!
!
ip domain name XXXXXXXXXXXX
ip name-server XXXXXXXXXXXXX
no ftp-server write-enable
isdn switch-type basic-net3
isdn logging
!
voice-card 0
!
!
!
voice service voip
!
!
voice class codec 1
codec preference 1 g711ulaw
codec preference 2 g711alaw
!
!
!
!
!
!
!
!
!
username XXXXXXXXXXXX privilege 15 secret 5 XXXXXXXXX
!
!
!
!
interface FastEthernet0/0
no ip address
speed 100
full-duplex
!
interface FastEthernet0/0.100
description *** Link to 2950 Fa0/23 ***
encapsulation dot1Q 100
ip address XXXXXXXXX XXXXXXXXXXX
no snmp trap link-status
no cdp enable
!
interface FastEthernet0/0.130
description *** Link to 2950 Fa0/23 ***
encapsulation dot1Q 130
ip address XXXXXXXXXXXXXX XXXXXXXXXXXXXXX
no snmp trap link-status
no cdp enable
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface BRI0/3/0
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn bind-l3 ccm-manager service mgcp
isdn sending-complete
!
interface BRI0/3/1
no ip address
shutdown
isdn switch-type basic-net3
isdn point-to-point-setup
!
ip classless
ip route 0.0.0.0 0.0.0.0 XXXXXXXXXXXXXX
!
!
no ip http server
no ip http secure-server
!
logging trap debugging
logging facility local1
logging XXXXXXXXXXXXXXXX
no cdp run
!
!
radius-server host XXXXXXXXXXXX auth-port 1812 acct-port 1813
radius-server key 7 XXXXXXXXXXXX
!
control-plane
!
!
!
voice-port 0/2/0
!
voice-port 0/2/1
!
voice-port 0/3/0
output attenuation 10
echo-cancel coverage 32
no vad
compand-type a-law
cptone IT
!
voice-port 0/3/1
!
ccm-manager mgcp
!
mgcp
mgcp call-agent XXXXXXXXX service-type mgcp version 0.1
mgcp dtmf-relay voip codec all mode cisco
mgcp validate domain-name
mgcp fax t38 inhibit
!
mgcp profile default
!
!
!
dial-peer voice 100 pots
description *** Gestione Chiamate Voce in Uscita ***
preference 1
service mgcp
destination-pattern .
port 0/3/0
!
dial-peer voice 555 voip
description *** Gestione Chiamate Voce in Ingresso ***
preference 1
service mgcp
destination-pattern XXXXXXXX
progress_ind setup enable 3
session target ipv4:XXXXXXXXXXXX
incoming called-number .
dtmf-relay h245-alphanumeric
!
dial-peer voice 556 voip
description *** Gestione chiamate Verso FAX ***
preference 1
service mgcp
destination-pattern XXXXXXXXXX
translate-outgoing called 1
modem passthrough nse codec g711ulaw
session target ipv4:XXXXXXXXX
incoming called-number .
dtmf-relay h245-signal h245-alphanumeric
fax rate disable
no vad
!
banner motd ^CC
^C
!
line con 0
line aux 0
line vty 0 4
privilege level 15
transport input ssh
line vty 5 15
privilege level 15
transport input ssh
!
ntp clock-period 17179212
ntp server XXXXXXXXXXXX
end
------------------------
BR,
Claudio
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide