Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi, i have a simple query.switch by default when receives frames to unknown destination broadcast to all ports rest of the port it has received the frame.so question here is //assuming there are 10 ports in the switchwhether switch will copy the or...
hi guys, is there a way to avoid fragmentation caused by gre tunneling (that is normal packet + gre header addition causes fragmentation)cpu cycles hits huge due to this fragmentation and defragmentation on tunnel destination anyone have idea ...
hi all, attached with diagramour 12000 series core router has 101 mbps link trminated to it.since its a core box there is a plan to new router as mentioned in diagram my question is which router model suitsfollowing requirementswith this new ro...
hi,step 1: enter the config mode of the router you want to make reachable from remote router.cisco>enable (to enter enable mode)cisco#config t (to enter config mode)step 2: enter the ethernet interface cisco#int eth XXXstep 3: assign ip address to th...
hi giuseppe, thanks for the effort u madeto make me understandbut still i need explanation.what happens on packet goes from first routerin 2 router whether it will use the routing table information to route to 3 router and 3 router uses i...
hi, assuming i am using tunnel destination after 5 routers first router when gets packet how it knows it should be on GRE tunnel ?after selecting tunnel interface encapsulation happens and with ip header source and destination ip address is addres...
