Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a remote location that connects to the central office via a private circuit (DS3). In the event this connection goes down, is it conceivable to failover to a IPSEC VPN tunnel using an internet ethernet interface on the router? The central si...
I am having problems with my 1841 router recognizing my HWIC-AP-G-A wireles card. I am running the following IOS: c1841-advsecurityk9-mz.124-3g.bin. I have tried placing it in slot0 and slot1. Any ideas?Thanks!
I have a Cisco 871 router which is connected to the internet. I would like to allow a few remote users to VPN into the office using the Cisco VPN Client. Currently, I can get the VPN Client to authenticate and connect. However, whenever I try ping...
I have 2 - 3550-48 port switches linked to a 3550-12T. Everything seems to be functional. However, I notice there are a LOT of dicarded packets on the ports between the switches. I was just wondering if this is normal to see for switch-to-switch p...
I have a remote Cisco 1841 which is currently configured to create a Easy VPN tunnel across a T-1 to a 3005 concentrator in corporate office. I would like to attach a DSL circuit to router's 2nd FE port to use as failover if T-1 goes down. What is ...
BTW ... I think the problem is with NAT ... Everything works fine if I disable NAT on the inside and outside interfaces. However, when NAT is enabled I cannot route into the private LAN when connected via VPN.
We are using simple trunking from what I can tell. However, it looks like there might be some unneccesary configuration lines under each port. This was setup by someone else.The core switch (3550-T) ports are configured like:interface GigabitEthern...
Yes, any pointers on configuration commands would be very much appreciated. Here is the current configuration:!hostname rtr-field!security authentication failure rate 3 logsecurity passwords min-length 6logging buffered 51200 debugginglogging consol...
I went ahead and remove the inspect statements and any ACL's that I had installed and the problem still exists ... the router can only route across the vpn tunnel if a specify the source interface to be the private ethernet interface. Unfortunately,...
