Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am new at troubleshoting on Cisco access points
I have 20 9120 APs, one of them is running as a controller.
Users experience wifi strengh dropping and being drop from a connected AP and graped by another AP. Some users don't have network connection...
I have one Cisco SG200-50 switch on my network and a AP 1602i. I have now also connected a Sonos One SL to the network.At first I had no problem setting up the Sonos and connect to it. Now after one day I am unable to connect to the Sonos with the ap...
I have deleted all files on my ASA 5505 firewall. I have loaded a image from a local tftp-server. When I after the reboot tries to set a IP address on interface ethernet0/0 I get this error:
ERROR: This command can only be configured on VLAN interfac...
The AP i am trying til troubleshot is in a classroom and all the students experience the issue.
The clients signal strenght, the teory is the claasroom AP goes unresponsive and clients at handed over to another AP.
When I try to run a Radioactive t...
Problem with the switch is resolved.I followed this article https://support.sonos.com/s/article/2118?language=en_US But there is apparently stil a problem with my AP. I cannot change from ethernet to wifi.
A little update.I have connected a little unmanaged HP 1410 switch to my network and then connected the Sonos to it. That gives me the possibility to connect to the speaker with a smartphone. Therefore it is the switch that causes the problem.
RunningAP01(config)#interface dot11radio 0
AP01(config-if)#antenna gain 0
AP01(config-if)#station-role workgroup-bridge multicast mode infrastructurereturnsDisable Multiple BSSID before configuring this station-roleAnd I have 2 ssid's on my AP, 1 for...
If I try to run the following command AP01(config)#interface dot11Radio 0.1
AP01(config-subif)#no bridge-group 1 block-unknown-sourceI get this errorno bridge-group 1 block-unknown-source <cr> not allowed on Dot11Radio0 interface
