Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Has anyone been able to connect their FMC to a Synology NAS via NFS? I get errors (obvisouly, it's why I'm here) as seen in the pic below. I have been able to connect NFS to a different Ubuntu server so I know they Synology can do it. Please s...
I am working on standing up a Cisco ESR 5921 on an Ubuntu server. I followed all the installation procedures and directions correctly, but when I start I receive the following error:
root@soft-router-test2:/opt/cisco/c5921# ./c5921-swr-init.sh sta...
So, it turns out that the answer was staring me in the face the whole time. Just need to check the "Use Advanced Options" box and enter "-o nolock" in the Command Line Options. This will allow connection to a Synology NAS with NFS enabled.
Each interface will have a MAC address. There is no device MAC address. Whichever interface you are connected to is the MAC address you are sending packets to and from.
Router#show interface fa0/0 FastEthernet0/0 is administratively down, line protocol is down Hardware is CN Gigabit Ethernet, address is 4c00.8262.3c99 (bia 4c00.8262.3c99) MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec, reliability 255/255,...
Finally got a homegrown solution to the console cable to use with the 1815w https://www.amazon.com/gp/product/B00QT7LQ88 Use this cable and the following pinoutpin 2 <-> whitepin 3 <-> greenpin 4 <-> black You'll need a 4 pin molex connector to get o...
