Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to setup a SPA122 to use line two in CUCM9.1 Have tried the MACo ffset like a ATA186, registration fails. What is the trick to getting the second line on a SPA122 to register with CM? Line 1 works fine, have tried adding second line to device,...
Have a 7600 running Hybrid mode. when we plug a new device into the switch side we are unable to see the device untill we ping its IP from the router side. WHen you ping the device the first packet no response then the rest of them come back. Befo...
I am looking into getting Fax software for intergation into Unity. What are the better third party applications that work with Unity? I have looked at the Cisco recomended ones. Just do not have reference as to which one is better or worse. If an...
Has any tried running CSPM 3.0 on a Win2k box? Has it worked, any problems? Does any one know if Cisco is going to release a version for Win2k specifically. Or should I just stick with a old Winnt Install? Thanks for any Ideas or comments.
I do not post in here often, but @ctbower98 was spot on with his info with the adapter from amazon. That worked perfect and saved me 40 days of waiting for a part that was no where to be found in stock anywhere. Thank You!
That is the strange part. The device is not able to ping anything untill the router has pinged it. And the mac only will show up after the router has pinged it.
