Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
<p>I seem to have issues upgrading the 2950 IOS via FTP - it usually just hangs and then I cannot access it for a while. I've tried copying the .bin or also tried the tar via the archive command - I've tried this via 2 FTP servers to rule out the ser...
Hi,I've searched on the net and still can't find a clear-cut answer. Could anyone provide a config example of this.Server A (in VLAN 10) needs to be accessible to PC2 (in VLAN 2), PC3 (in VLAN 3) and PC4 (in VLAN 4).If I have a 3550 switch, I should ...
I am connecting 2 locations via a DS3, but I have seperate Adtran units that will be hooked up to the DS3 itself, providing the clocking. So the routers will be hooked up to the DS3 via the Adtrans.On both sides I will have a 3550 switch connected to...
But how does VLAN 2,3,4 access VLAN 10 and how does VLAN 10 server access 2,3,4? I saw something about using sub-interfaces. Do I have to use sub-interfaces or is there another method I didn't mention?Another config example would be great too, thanks...
Thanks for the info, but no I don't have it up and running yet. I just found this config online and wanted to know if you guys had any additional recommendations or suggestions, or if you guys see any problems with this config?
I am connecting 2 locations via a DS3, but I have seperate Adtran units that will be hooked up to the DS3, so the routers will be hooked up to the DS3 via the Adtrans.On both sides I have a 3550 switch connected to the routers FE100. Ihave servers on...
