Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got 2 SG300 switches connected to a SimpleWAN Firewall. The Simple WAN device has LAN subnet (I assume VLAN1 default) of 172.168.1.0/24, VLAN50 10.50.0.0/24, VLAN70 10.70.0.0/24, and VLAN200 192.168.1.0/24 all going out of the LAN interface and ...
I've got a client with some old Catalyst 3750 Switches that are setup so telnet is only allowed if I'm on the management int. I need to access from other interfaces and am not sure how. I know this is a simple command but I dont touch the CLI often e...
I've got a client with an old ASA5505 (Cisco Adaptive Security Appliance Software Version 8.4(4) Device Manager Version 6.4(9) and they have 5 public IPs. I've natted one of the public IPs to the inside address of a SimpleWAN firewall. The SimpleWAN ...
This is precisely what I want to do. My question is I've only got 1 block of 5, 4 of which are being used on my ASA. I want to know if I can assign the simple wan interface the remaining IP and route to it through an interface on the ASA.
