Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need some help here. I am trying to configure a router for access privileges.Following is the configuration:-enable secret level xxxprivilege configure level 14 interfaceprivilege configure level 14 interface shutdownprivilege configure level 14...
Hi,I need some help here. I am trying to configure a router for access privileges.Following is the configuration:-enable secret level 14 5 $1$yQtt$0yL38AHKDnpuLO3MMaGi3/privilege configure level 14 interfaceprivilege configure level 14 interface shut...
Hi,I need some advice here. I am trying to configure a router for access privileges.Following is the configuration:-enable secret level 14 5 $1$yQtt$0yL38AHKDnpuLO3MMaGi3/privilege configure level 14 interfaceprivilege configure level 14 interface sh...
Hi,I have 2 Catalyst 3550 switches, Switch A and Switch B. Switch A is connected via trunk port to switch B. Port 1-23 of switch B are in vlan 101 whereas on port 24 trunking is enabled with switch A.Now I want ports 1-16 of switch A (which are in vl...
Hi,Consider a situation in which ASA's outside interface with a security level of 0 is connected to the WAN router's ethernet interface. Is it possible to send SNMP traps from this router to logging software residing on the ASA's inside interface wit...
Hi kumar,Thanks for your response and helping out..while tweaking around my initial posting, i stumbled upon what worked for me and this works now..--Noman Bari
Hi Raj,Thanks for the suggestion..but I figured out that i was doing the right thing but missing one important point..the thing is since i have configured level 14 user to configure the ip address in interface mode, in the sh run (while in level 14) ...
Hi Raj,i have resloved one major issue regarding configuring interface but if u can help me with show run command execution then that will be great...--Noman Bari
Hi,Just resolved one issue..Added theseprivilege interface level 14 shutdownprivilege interface level 14 ip addressbut the issue of seeing running conf remains : )..--Noman Bari
Hi Anton,Thank you for your response. I tried adding configure command (after I posted here) but the problem persists. I added privilege exec level 14 configureprivilege exec level 14 show running-configbut still level 14 user can't see the running c...
