Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I require to change the time zone on a SNS3415-K9 which supports ISE 1.2 platform. I try to make the change but the application does not respond. I need to know if there are any special procedure for this?
I have a Call Manager Express 8.6.1 and a Services Module (SM) with Services Ready Engine (SRE). I´m trying to install the Unity Express 8.6.1 version but when the system starts uploading the packages it aborts the package extraction "cue-install...
Hola,Tengo un Call Manager Express 8.6.1 y un Services Module (SM) with Services Ready Engine (SRE). Estoy intentando instalar la version de Unity Express 8.6.1 pero cuando el sistema empieza a subir los paquetes aborta la extraccion del paquete "cue...
Hi, I have a Cisco Presence 8.0.4 Integrated into a CCM 7.1.5. Initially set two end users in the CM which were imported logearme Presence for a Unified Personal Communicator 8.5.3. Both users and service log in successfully operate properly. Then I ...
Hi, Brothers.I´ve a Call manager express in a 2811 router with IOS version 12.4. I´ve had this platform installed since a couple of years ago but few months ago it started presenting echo in the FXO ports that I’ve configured with analog lines for co...
If this had already done from ISE 1.2 Administration Guide. I request to suggest me if once set the Time Zone again can change without affecting the operation of the application or the initial Setup should run without reinstalling the application of...
Sandy, you indicate is the procedure for NAC, but the platform where you have the problem is a ISE 1.2.The ISE 1.2 does not allow the time zone settings for the web environment it is performed by CLI.
Hi everyone, I´m currently managing a Unity Connection 8.0.3.10000-18 which supports the voice mail and auto attendant services for multiple clients, at this moment it is supporting around 1000 users. a couple of days ago people have been reporting t...
Ok, this platform was working from December 2010 and its having this behavior since last weekend. It seems that the signal that must be sent from the Unity to the Ip phones is not getting thru or it is not being sent. Is it possible that there are...
Sorry, this profile transcoder already configured on the Call Manager and this typed Transcoder: Cisco Media Termination Point Hardware.I really need to know is if the Call Manager 4.2 supports DSP resources configured with PVDM III. And if so additi...
