Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been trying, without much success to try and find a solution for connecting a Cisco 2620XM router to a 2mb Circuit that is presented as G703 unframed (the physical presentation is RJ45 - 120 Ohm unbalanced). Could anyone suggest an appropriate...
There are other reasons the OSPF adjacency could fail with the log message "Too many retransmissions". For example, two switches connected with a Layer 3 Port Channel, which might be misconfigured at one end, such that the Port Channel comes up, but ...
Have you got your APs set up on the WLC in local HREAP mode? If so you are likely to have configured VLAN mappings under the HREAP tab. If the AP has lost its VLAN mappings it will revert to the local VLANs known by the WLC rather than the VLAN(s) u...
Thanks for you reply. (1) The country we are working in is France. The Circuit goes between the UK and France.(2) This is not a PRI as far as I know. We are using this a PTP serial link at a speed of 2mb. I have tried using the two types of linecode ...
Thanks for your response. I have already tried three different cards in the back of the Cisco 2600 router. The first was a basic WIC-1T card with X21 connection, the second was a VWIC-1MFT-E1 card and the last was VWIC-1MFT-G703 card. I was unable to...
