Hi There,
I have couple of question related to NAT.
1. I have a requirement to NAT the specific traffic receiving on the interface to be NAT to the interface IP itself. I have simulated this with the below syntax.
!
interface GigabitEthernet1/0
ip...
Hi there,
I have a requirement to NAT source ip address list to a single ip address. The NAT ip address is already overlap with the interface ip address subnet, hence I can't overload the NAT to a /32 loopback ip address. I plan to use a single ip a...
Hi There,
We are about to deploy Cisco Catalyst 9000 series. We wish to run on the perpetual license only and deactivate the DNA subscription license. In future we plan to activate the DNA subscription license. As I went through the release note ca...
Hi There,
I need an advise on Cisco Stackwise cable connectivity option. I have to deploy a stack of 4 switches contains Cisco 9300. Cisco recommended connectivity option is as below.
But unfortunately I have only 50CM stack cable only hence I c...
Hi There,
We are deploying Cisco 6807-XL and below is the show version output.
Cisco IOS Software, s6t64 Software (s6t64-ADVENTERPRISEK9-M), Version 15.3(1)SY2, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright ...
Hi Andrew,
Thanks for the reply. Actually I am not using NAT for ISP connectivity, rather I am using it to overcome some duplicate IP segment in-between the local and remote sites. My client requirement is to definitely overload to the NAT inside i...
Hi Andrew,
Thanks for the reply. Actually I am not using NAT for ISP connectivity, rather I am using it to overcome some duplicate IP segment in-between the local and remote sites. My client requirement is to definitely overload to the NAT inside i...
Hi luis_cordova,
Actually the requirement is to NAT to the specific IP (10.10.13.101), retaining the existing interface ip address. Hence I cannot change the interface ip address at the router.
Hi Leo,
Thanks for the feedback. How to confirm the license activated in 6870-XL. Because generally for the other catalyst series we have
show license
command to check this.
Thanks
Prashanth