Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 13 sites each with an ASA 5505 and a Cisco 1602i directly connected to ethernet 0/7 via short 3 foot cable that came with the AP.At 3 of these sites, I have an issue where one or both PoE ports go out randomly. Sometimes uptime will be a week,...
I have two 2901's currently connected with a site-to-site T1 connection. The company is looking at using Cradlepoint 4G modems as a failover connection between the sites. I have created an IPsec VPN tunnel over the Cradlepoints, but I can't figure ou...
I have an issue that's been bugging me since this morning. This site has a single VLAN, 1, and the gateway is an SVI for VLAN 1 with a secondary IP of 192.168.116.254/24 and a primary IP of 10.53.16.1/22.Some clients on the 10 network can ping server...
I'm dealing with an Oxinet III device which has a Gigabyte GN-WI01GS wireless card in it. The device will seemingly connect to our WPA2-PSK (AES) secured network, but trying to ping the device is not successful. The device's GUI will show that it is ...
I have 6504 connected to an Enterasys N3 that I cannot manage and the guys that do aren't very helpful so I don't know much about the Enterasys side other than that it is running MST. There's an ethernet trunk between the two and I'm trying to get th...
So I have RMAd 3 ASAs with the same problem and the replacements seem to be doing good. Everytime I called TAC and explained the issue, the quickly came back and said they would have to RMA the ASA.
Thanks for the assistance and I have tried looking into IP-SLA, but I can't figure out how the local traffic would route through the VPN. I have no problem configuring IP-SLA for routing traffic straight to another gateway, but when the VPN is involv...
Yes, all your assumptions are correct. Question on this:ip route 10.2.3.0 255.255.0.0 166.139.144.156 OR Fe0/1 120If I specify 10.2.0.0 255.255.0.0 Fe0/1 120 with my current config, I suppose the router knows how to route those packets since it has a...
I have attached a diagram and running configs.Basically, I'm not sure how the IP-SLA would work with route statements pointing to the Cradlepoint's gateway. So if I send all 10.0.0.0/8 traffic to the Cradlepoint gateway, wouldn't it reject all that t...
I have not done a packet capture yet.Yes, the PCs have the correct default gateway, they all point to the 4500s.Yes, both the client and servers are in the ARP tables of the 4500s.
