Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we have a typical Dynamic to Static IPsec VPN setup between Site A(Hub) ASA and SiteB(Remote) ASA
The tunnel sets up fine when we initiate traffic from remote side.
Question Once tunnel is setup for a particular IPsec SA (Site B (Host A) to Site A (S...
Hello, Im new to the ASR920 service instance but would like to know if anyone has done traffic policing on a service interface. Scenario is multiple service instances servicing multiple downstream clients configured on a physical interface. I would l...
Hello,
I have a setup with a 5696Q linked to TOR 2232TM-P running version 7.
I''d like to know if L3 ports are supported on the FEX and second question if routing (i.e. OSPF) can be sent through it.
I found an article online and tried the commands ...
Setup
phones---------CUCM------------CME---------ASA------Internet----------SIP Provider
We have an issue where outbound calls through our sip, signaling completes but we dont get audio. In the other direction Inbound sip calls work fine.
From the...
Well we seem to have fixed outbound sip calls but inbound is now broken. Running traces on inbound calls on the gateway i see this issue. The dial peer 300 routes to the CUCM where extension range 300-350 sit. Im suspecting an issue on the CUCM.
009...
Hi Tim,
Works now. We had previously just repointed the existing SIP trunk to the new gateway ip address.
We deleted and recreated the SIP trunk on CUCM. Best practise i read on a forum.
