Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question on configuring Cisco ASA with multiple certs. I am new to configuring MCI to cisco ASAFor the identity Certificate on the same appliance, we generated CSR and generated the pkcs12 certificate outside the ASA appliance.My question is...
So we have an existing vpn setup abc.com and we have a setup a new vpn system pqr.com. We want to migrate from abc.com to pqr.com such that the end users when they type abc.com on their vpn anyconnect client they should be redirected to pqr.com. Mini...
I have a Cisco C9300 switch and the port does not link up when connected to WS-C4506, however when i connect the C9300 to a 2960 the same port links up.Is there an issue with a catalyst switch port not linking up when connected to another catalyst sw...
While upgrading a c3850 switch from 16.3.5 to 16.6.8 in the install mode, i am came across the following issue:Booting...cf_identify_drive: cf_waitfor(!(BUSY | ERROR)): timed out.Boot bus: Failed to detect any IDE storage!Interface GE 0 link down***E...
Hi, we have a couple of Cisco 9508 running version 10.2.2. These devices have licenses local to the device (stored in the device itself). We have a Cisco On-premise Smart licensing server running in our network. My questions are;- Should these device...
So the issue is with the version, so i upgraded to 17.09.03 and the issue is resolved. I tried the upgrade on 2 switches and it worked. So the version 16.12 has the issue.
If there was a mismatch should not the port first link up and then throw an error? It does not recognize the port at all. It always throws up as "not connected". Also if both the ports are trunked or access ports i would still be able to recreate thi...
just to update after almost 45 minutes now, the link is up between the C9300 and WS-C4506 , here are the details:On port 47 of C9300:Switch#sh run int te1/0/47Building configuration...Current configuration : 42 bytes!interface TenGigabitEthernet1/0/4...
