About grequena

grequena · 07-24-2005

I have two 2811 with CCME in one location. Each of them has four ISDN interfaces to PSTN network.I think that two solutions are possible:a) Every IP Phone will be registered to primary 2800 CCME, and if this goes down the IP phones will be registered...

grequena · 03-15-2005

I have a scenario where, one hub site which is connected to metro ether MAN at 1Gbps and spoke sites are connected to metro ether MAN at 100Mbps, in these remote sites variable bandwidths are agreed with service provider: 20Mbps, 40Mbps, etc.I only w...

grequena · 10-13-2004

Hello.I have got below network design: Ethernet A ------------------ | | |------| | R0 | |------| / \ / \ / \ |------| |------| | R1 | | R2 | |------| |------| | | ...

grequena · 09-29-2005

Hi Michael.I have got to have working a fax machine in "phone 1" port of the ata-186 (I have just done the procedure that you describe: "... create and ephone, type is ata, and assign a single line ephone-dn to button 1."), but the second port is "mu...

grequena · 07-26-2005

Hello.I have found this:http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080aec.html#wp1244361Here, the problem that they solve is the inverse problem that I have, but I hope that the soluti...

grequena · 10-15-2004

OK, thank you very much.I am going to test your advices next week in one working network. I'll tell you about the results...Thanks again.Best Regards.

grequena · 10-13-2004

The network design in a .txt file

Member Since	‎10-13-2004 03:56 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	7

User Statistics

User Activity

two 2811 with CCME...how to get redundancy?

Traffic Shape in ethernet - C3750Metro

Choosing one preference neighbor router running OSPF

Re: Configuration for ATA with fax on CCME

Re: two 2811 with CCME...how to get redundancy?

Re: Choosing one preference neighbor router running OSPF

Re: Choosing one preference neighbor router running OSPF