Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all, I have a 2811 router that works as IPIPGW from h.323 to SIP. It has PVDM2's installed on the board of the router (so no NM-HDV or AIM installed). I cannot figure out how to configure this router to perform transcoding of voice channels. Is ...
Hello all!We have IPCCX 4.0 installed with CCM 4.2 and CAD installed on Terminal Server. Agents log into 7940 phones using Extension Mobility and then using Remote desktop connectin they log into CAD. Everything works perfectly well. Supervisor Deskt...
Dear friends, thank you for your patience in waiting for final resolution on this. This gateway was in production, so I had to wait for the right time to shutdown it.Removing E1 card finally resulted in releasing enough DSP resources to turn dspfarm ...
Thanks for help!I have 2 ISDN E1 interfaces and 4FXO interfaces on this router, with 64PVDM2.Show run:::!version 12.4service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname voice-gateway!boot-...
Appologies for the inconvenience!Hope this works fine. Thank you!DSP DSP DSPWARE CURR BOOT PAK TX/RXTYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT==== === == ======== =======...
Thanxs for help!I am having problem in turning DSP profile in "ON" state.Please find attached reply from the router on "show voice dsp".The router has one 4xFXO voice card and one 2-port E1-MFT (only one E1 is used). PVDM2-64 is installed on the moth...
Thanks for help!However, it did not work for some reason. I followed the instructions and here is what happens:voice-gateway(config)#voice-card 0voice-gateway(config-voicecard)#dspfarmvoice-gateway(config-voicecard)#dsp services dspvoice-gateway(conf...
