Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I got the strange messages on my wism(v4.1.158.0)Jul 03 14:41:24.148 apf_foreignap.c:1246 APF-1-REGISTER_IPADD_ON_MSCB_FAILED: Could not Register IP Add on MSCB. MSCB still in init state. Address:00:1a:70:a6:b9:feJul 03 14:41:22.821 apf_fore...
Hi there,I applied the uufb on the 4506 switchs yesterday and everythings are seemed to be OK.but today some printers were can not be conneted through the LAN.I can see the arp of the printers on L3(Cat6509) but I can't see the mac on L2(Cat4500).I d...
Hi there,I have a WLC4404(v4.0.219.0) and several APs on my network.Those APs are belonged to a couple of vlans.I planed to add a new WLC4404(v5.0.148.0) on same network with a old one.I configured the new WLC4404 as a primary controller of the APs a...
Hi there,I have a problem with a WLC.Wired PCs whthin a network belongs to one of the dynamic interfaces in WLC can not access WLC. The PC can not ping to WLC Mgmt. interface, also.I don't understand why the PC can not access WLC through ethernet.I k...
Hi there,Recently, I can not log on my WLSE.I can access the port 1741, and the log on screen displayed.I enter my account and WLSE display like this."WLSE is currently loading information. You will automatically be logged on when loading is complete...
I didn't configure mobility group.Is the only way to anounce the IP of new WLC to the APs?Can't they find ip address of the new WLC on same subnet with old one without configuring mobility group?
It doesn't matter if the ap have to upgrade its code and I intend to upgrade the code of APs.But the APs couldn't find the new WLC but the old one.That's the problem.
Dose the only management vlan work, if the different version of WLC is existing on same network?They are totally same except IPs, hostname and dynamic interface IPs as you said.
Hi Ankur,I have experienced same thing on other WLCs and some codes too.WLC couldn?t communicate with the client in wired network belonged to Dynamic Interface network.I don?t believe that there are not routing issues on this case. Because, the PCs ...
I tried boot the system as CiscoBreR or using Recovery CD. (I think both modes are same mode.)But the system message is still "uncompressing the image". I don't know what the problem is...Could you help me?
