Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My situation is that one of the sites in my client's enterprise already has Unity v4.0.5, and works fine the AD was previously extended.Question: we're now adding Unity v7, does the AD have to be extended again? Or is the existing AD good enough? If ...
Greetings.I'm putting a new 7920 phone on an AP1231 access point with open access but mac authenticated. I already have one 7920 phone active on the same network, so everything is setup correctly.But, debug dot11 connection failure in the AP shows th...
Greetings.My AP1240AG runs 12.3.11-JA4 code, works fine, but I can't enable https on it, SSH is working fine. I need both https and SSH both.I've tried the same config on my 1231BG units, and that works perfectly with the same config.Anyone heard of ...
I tried today to upgrade my 1841 Adv Security from 12.4.6T7 using sdf v4 files to the newer v5 12.4.11T3. All went well with the initial config, three basic signatures activated. I used the v296 pkg file for the latest signatures.When I tried to copy...
I've got an 1841 that I'm booting with multiple boot statements and images in flash for some testing. I've found a problem where I have say 6T6 and 6T3 images already in flash, but I then add in 9T1 as my third image. Make the edits to the boot state...
I had this problem quite some time ago, and TAC explained that this is by design. The intended effect is to prevent a DOS/DDOS attack by intentionally not processing all icmp packets.-Jeff
I've seen this problem before, and it was a fragmentation issue. I had to create a route map and apply it to the client site so that the DF flag was cleared. This then enabled fragmentation on the client side prior to entering the MPLS CE WAN ckt fac...
I never specify the fax rate in the mgcp config, but rather do it in the ATA config file if I need to customize it.Give that a whirl.Also, you didn't say what model of gateway, IOS and version, etc.-Jeff
