Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Hope you are all doing well !I have set an special SNMP monitoring for AP MIC certificate expiry date on my monitoring system. For WLC i could add the MIC ignore command "config ap cert-expiry-ignore {mic|ssc} enable" But how to deal with AP ...
Dear All, I have a quick requirement for adding more additional switch, can I know : What is the maximum number of switches that can be stacked using Cisco StackWise Virtual using 9000 Series switches ? and recommended firmware it supports ? Regards...
Dear All, I am looking for command to check and know AP radio status from controller via SNMP as I want to add the Radio status to my customized dashboard.Could someone please help me, if there are any commands RegardsSharath
Dear All, I have a strange situation, WLAN clients not able to get IP address from DHCP pool and not getting authenticated- WLC Interface which are used by other WLAN works well, clients gets IP address and works well. - Same WLAN configuration works...
Hi All, Observing strange issue : After reload of WLC in HA mode, observing some AP licenses disappeared from total AP license count.steps followed for the change : - broke the HA - reloaded- Disabled the unused ports ( as this was cause of change )-...
HI,Vlan 608 is reachable and SAS-default is the AP group and required SSID isadded.Actually I solved the issue as there was mac filtering enabled in WLAN andin security tab > mac filtering > Free Radius was enabled ! as results WLCand radius key was ...
Hello Sandeep, Thanks for the prompt response, When HA was broken box itself asked for saving the config and I have saved the config. I will soon open the TAC case. RegardsSharath
