Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm searching how as administrator can I check or modify PAB entries for all users without use the User Web Access.Anyone an idea ?Thanks in advance.
Hi,I've an H323 gateway with a VIC2-2BRI-NT/TE to connect directly an ISDN Phone. I'm searching to display a name for this phone when it call an IP Phone. Anyone an idea ? The station-name voice-port command doesn't work with BRI interface. Thanks
Hi,I've in lab a version of CCM 5.0.2. A scratch installation work fine but in upgrade case something isn't OK. I've used the DMA 5.0.2 tool to migrate my DB without problem. After the migration no phones ( 7960, 7961, 7941, 7970, 7905 ) can upload t...
On CCM 4.0(2a)sr1a I've a line group with two DN's. I try to configure a Forward All on one of the DN belonging the line group but it doesn't work. The call is never forwarded to the destination number.With Pilot point and Hunt group it's possible bu...
Hi Fredrick, thanks for your response. We've configured tcp-adjust-mss at 1363 byte value and our performance problemdon't exist anymore.Preventing FragmentationUnfortunately, there is no method to prevent LWAPP fragmentation in the controller or acc...
Hi sreelalggbm,Finally did you find the source of your problem ? We have the same performance problem and there is nothing to do withhalf-duplex. We have determined that guest's PC's with MTU set below than 1432 are working fine. With bigger MTU's se...
Hi, I have exactly the same message in our log with the same IOS. However the difference is the faulty port is actually not used and is disabled...Could be a bug on this version? I have many other catalyst 6500 with many 10G modules and different IO...
Hi,The URL is http://PUBLISHER IP:8080/ccmpd/pdCheckLogin.do but it doesn't work. On february I've asked the TAC and this is the response : "We fixed this in 6.1(2) scheduled for FCS May 2008". I've tested this version this week and it's still not OK...
