Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear experts,I need help with my UC-560-T1E1. I'm trying to enable Meet-Me Conference. Using CCA --> Telephony --> Voice Features + Enable Multi-party Conferencing+ Mode G711 ( All phone use G711 as well)+ Maximum Multi-party session : 2 (1 for adhoc...
Dear experts!We are planning to deploy a UC540 system along with our current PABX. PSTN --> PABX (with anlog phones) --> UC540 --> IP PhonesWe have some questions that need your help to clarify before deciding to deploy it.1. Are there any problems i...
Dear experts!I see that Cisco LAP 1240 support Mesh mode, but I am not sure if LAP 1250 support or not? I can't find any document that say about this.Best Regards!
Dear experts,I have 1 2960 switch. I need to separate traffic from each switch port to the others except for one or more common ports.For example. I have 3 ports: 1,2,3. I need to make sure that- Traffic from port 1 can not reach port 2 and vice-vers...
Dear Paolo,Tks for your answer. Please help me with some more questions!1. As you said that It will be fine if I have 10 users at a remote site. Can you please explain what does "5 Users per teleworker site" limitation mean. 2. To clarify my plannin...
Tks for your replys so much,As checking some guidelines I see that 2960 only supports PVLAN EDGE (PROTECTED PORT).Please tell me that if PVLAN EDGE will work in my case or not ?A sample configuration for my case (3 ports, port 3 is the common one) i...
