Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we have CUCM in two nodes cisco MCS 7800, after the jump in electricity in one of our node the first ethernet port stopped working. How can i set a new ip addres for the second port?I tried it to do it in cli, but after save the conf still showin...
Hi, can you please answer, do you have some some literature or manual for intagration messenger with UCCX? We have UCCX also and a little familiar with dockers, it would be pleasure to know how deploy. my mail simulator00@gmail.com Thanks for answer
Hi, thank you for your suggestions, but actually, i don't know what's happened but after i turn off first NIC port and reboot the system, the second NIC port started work. I used ? for different command but couldn' find the command to switch between ...
What's mean HA - high availability ? How can i define is my eth0 works now or not? The indicate of first port doesn't show nothing and the link status on ILO the same. The second port is fine. Here i've found that can configure the NICs in an active...
