Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, All,Our existing T1 was just replaced by ATT due to its network conversion. The new T1 is much slower than the old one. We had ATT run the test and they told us there was nothing wrong with the new T1.This is the only thing that was changed in ou...
We had a T1 from local bell company that has been worked for years. The local bell provides clocking for my Cisco T1 module. We had a Cisco 1700 with T1 module and here is the configuration on serial inferfaces:Our Existing configuration (working wit...
Hi, All,I am new to MPLS. Currently I have three branches connected to my Central location. My central location used 2800 series router and three branches all use 1800 series router (with T1 WIC modules). Currently, each branch connects to the centra...
I have a 5505 base model and I am trying to create a DMZ. In 5505, I can only create a limited DMZ with (no forward interface vlan) command. My objectives:1. My webserver is in DMZ. DMZ needs to initiate traffice to outside to get Windows updates. DM...
I have a simple network. My host is in 192.168.1.0 network. I have a T1 connect to my remote network that I assign 192.168.10.0; Due to some of my legacy device doesn't do routing. I need to put both my remote and host in the same subnet (192.168.1.0...
I tried the first three options. ATT insisted that my router needed to provide "clocking" and refused to come to my site to run end-to-end testing.Everything worked before I moved the cable from the local bell's jack to ATT's jack.Option 1: (Tried, D...
Everything(router, T1 module and cables)(worked before with the local bell company's T1. All we did is simply move from local bell's jack and ATT's jack.Try this too:location A clock source line and making location B clock source internal. Still not ...
There are two options that I can also try:nat everything from 192.169.10.X network to 192.168.1.XOr USE IPSEC-VPN between two sites.If I do Nat, what change I need to make? Thanks
You are correct. PIX 6.35 doesn't support extended access-list commands. Also, I can't do both of these commands at the same time.nat (inside) 0 access-list 101nat (inside) 0 access-list 102So I use access-list 101 for both.access-list 101 permit ip ...
