Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.
I have a scenario here as per diagram. All the Route/Switch (R/S) is NXOS
Router/Switch (R/S)Site A has multiple static routes to (R/S)Site B. Site B also has multiple static routes to site A and at the same time has ospf running and redistrib...
Hi All.
We have a scenario when ASBR router has redistribution between OSPF and EIGRP, we can see that the default routes coming from OSPF rather than the EIGRP (where it should). The diagram is as attached
At the B_UP & B_DOWN we have the route-...
Hi All.
I have a situation here where I got specific routes need to change the AD in EIGRP. I attached the diagram.
SW5# show ip route 10.176.10.0IP Route Table for VRF "default"'*' denotes best ucast next-hop'**' denotes best mcast next-hop'[x/y]' d...
Hi.
I still experiencing the EIGRP routes stale in the ACI even after upgrade from 14.2(3j) to 14.2(7f). Can verify is the version already solve the issue?
Hi All.
Is there anyway to make the network base attributes in ACI microsegmentation using ip range rather than single ip? Let's say in the epg I have a range of IP 10.1.1.100 - 10.1.1.200 to be include inside the attributes. In normal config I have ...
Hi Enes Siminica.
I'm not actually get it what are your statement. I have the set tag of 3001 for the default route in EIGRP-TO-OSPF and match ip address prefix-list DEFAULT and have deny it in route-map OSPF-TO-EIGRP deny 10. Need your help where wa...
Hi Leo.Here is the snapshot when I type the logging syslog.com. You can see thatwhen do sho run it will change the name into ip address.*BGI_C2960X_Test(config)#do sho run | inc logglogging buffered 16000informationallogging console criticallogging o...
Hi Leo.
Thanks for the response. What I mean is when I add the config
conf t
logging host syslog.com
when I show run | inc logging
it will show me the IP address instead of syslog.com. How to get the show running with the syslog.com instead of the ip...
Hi All.
When i configure the logging host <hostname>, it will show IP address inside the logging host show run instead of the <hostname> that i've just type. Any help on this to retain what i have just type in the show run config?
