Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In my lab, I have a Dynamic VTI established between two routers. I'm exchanging routes via bgp between the two routers. Off my Branch VPN router (VPN1), I have a router(Node8) with a loopback and a point-to-point interface to the VPN1. My DVTI is up...
We have kind of a strange situation going on. We have a web server hosted in a DMZ located off our DMZ interface on our ASA. This web server has two NICs one of which is in a management vlan connected directly to our core switch bypassing the ASA the...
I have a request to forward a line after no one has picked up to a different extension but if that person doesn't pick up have the original forwarding extension pickup.
In Short;
extension 1111 forward to 2222 if no answer
if there is no answer on e...
Hello,
I have been tasked with upgrading a pair of ASR1002 (2RU) they are currently running 12.2(33r)XNC firmware and ios Version 15.3(3)S5. We will be upgrading to 9.03.13.05.S.154-3.S5. As per the release notes it is necessary to upgrade the ROMMO...
Hey Paul,Thanks for your reply. I was completely out of ideas last night, and I decided to go ahead, and migrate my routers from a dynamip 7200 image to an IOL image, and after doing that everything is working as expected. I made no other changes to ...
If they are directly connected, than you should not need a static route for all the subnets. They will already be in the table as connected. You should just need the static route on Site A > Site B Vlan 3 like you had in your post.
Thanks for your response, if it was my network i would :). Unfortunately, we only manage the firewall and a few switches for this customer. The vendor was adamant when i spoke with them last about it not being an issue on their side and was quite dif...
