Member since ‎11-13-2015

User Statistics

  • 22 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

Hi, I am facing an issue which I can't get my head around.  I would like to limit inbound traffic from the outside interface i.e. the WAN.  I have created an ACL and applied it to the WAN interface inbound.  However whenever I apply it, the ACL seems...
Hi All, I have successfully implemented ISAKMP and IPSEC for a site to site tunnel from a Cisco 881 to a non Cisco device.  Here is what the set up should look like... Remote Side                                                                       ...
Hi All, We have some Cisco 897's in our network and we also have Cisco 881's. I have been using Cisco Configuration Professional to manage the 881's.  However CCP is not compatible for 897's and I was wondering if there was something out there simila...
Hi, I would like to restrict incoming WAN traffic from a specified WAN IP to a specified LAN address. Public WAN Ip ---> Router outside address ----> port 16992 I previously had a NAT forwarding as per below but I would ...
Hi All, I have recently put in a new Cisco router 881 at one of our sites.  I have installed a few of these in the past with no issues with SSH. However with this one, i am facing the issues whereby i cannot SSH into the router via the public WAN.  ...
Community Statistics
Member Since ‎11-13-2015 03:35 AM
Date Last Visited ‎11-29-2020 02:24 PM
Posts 22