Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured three Catalyst centers as a cluster, but the management IPs of all the Catalyst centers are not reachable. When I ping the management IP from a connected fabric switch, the Catalyst center receives the echo request, but there is no ...
Dear All,We have one ASR 1001-X Routers in the existing environment and we are using BGP as a routing protocol to reach other 20 global locations and OSPF to reach internal LAN. But now we want to use the C9500 Switch in place of ASR 1001-X Router du...
Dear All, I have a ASR 1000 router which 10G port are in EULA License. I have the License but I don't know how to activate this license for 10G port. Please guide me.
Hello Everyone,
I want to know that how port utilization is calculated on Router if we have below Tx and Rx Load. Can I combine both Tx and Rx percentile while calculate utilization.
Note :- We have 2gbps P2P link. below example calculated with 2 Gbp...
@Giuseppe Larosa Thank you for your valuable information.Let me use C9500 Switch in my network scnario and update you with my experience. Thank youRegardsDipu Kumar
@BDG Thank you for your prompt response.you are right, When I study Cisco Doc about C9500 Switches then I thought we can use the C9500 Switch.We are also planning to buy ASR 1002-HX but we want to use this Switch for 2month till receiving the ASR 100...
Hello @Giuseppe Larosa Thank you for your information.I am sorry, I forgot to mention in the above post. We are using VPLS connectivity between our all locations and in this scenario, ASR routers don't receive any route from PE, ASR routers receive r...
