Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it best practice to have the mgmt IP of your controllers on separate subnet from your switches? In other words is it OK to have management IP of switches, controllers, etc on the same subnet or is it smarter to create another separate one just fo...
On a 4 stack 9300 the SW Version displays RELEASE SOFTWARE instead of the actual SW version of 16.6.4.a. Show switch command output appears normal. Show inventory the switch doesn't up. Clients are on the switch and working fine. Any ideas? XXXX...
On a 5508 with 7.4.110 code I have clients going out the global interface (on the WLAN itself) rather than the interface stated in the AP Group config. The users are then just hanging and not getting a DHCP address. I verified the AP(s) are in the g...
Maybe I'm not explaining this well but here goes last try-
I'm building out a new building. It has (1) controller (9840) and (5) LAN switches (9300s). IS IT BEST PRACTICE to have the management IP of the SWITCHES on a separate SVI than the CONTROLL...
Yup I get that but it doesn't answer the question. Is it best practice to have only the wireless controllers on their own SVI, Subnet , Network? In other words if my controller is using vlan 100 -10.10.100.x/24 is it best practice to NOT allow othe...
So switch 4 is not showing up in the show inventory command. It accurately shows switches 1-3. In the output Switch 4 is showing Release Software instead of showing the code version (16.6.4a).
