Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I am trying to Nat public ip on outside interface of pix to a local server inside, When I configure nating, Internet browsing works only on server no one else can browse internet.nat (inside) 10 0.0.0.0 0.0.0.0 0 0static (inside,outside) int...
I have two internet Links 1 Serial and 1 ADSL terminating on same router, Need to route SMTP Traffic from serial int and all other traffic from ADSL, 1. Which will be my default route (Serial or ADSL)2. Adsl is configured for DHCP how will i use !set...
When i boot my PIX 501, it get stuck over hereany clueRegards manishCISCO SYSTEMS PIX FIREWALLEmbedded BIOS Version 4.3.207 01/02/02 16:12:22.73Compiled by morlee32 MB RAMPCI Device Table.Bus Dev Func VendID DevID Class Irq 00 00 00 ...
Dear All,I have router with ADSL interface and Serial Interface, how can I route SMTP Traffic from Serial Interface and Internet traffic from ADSL interfaceThanks in advance Manish
Try using “ip rip send version 1 2” command on the router running rip2, this allows neighbors running RIP1 & 2 to talk to each otherHope this helpRegards Manish
Thanks Scott,but my email server is hosted in side of my network.The catch is, if my email server route mails via ADSL Interface (Dynamic IP), recipient gets as a Spam and cannot reply to those mail, that's why I need to send emails via Serial interf...
I was able to fix it,What you need to do is open PIX Firewall Chassis,Next to Bios Bettery, there is a jumper. Just change that jumper setting and it should start workingRegardsThanks every one for there replyManish Young
