Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It appears Cisco has changed how basic 1:1 Static NAT works post 17.3.1a. I have a working setup based on another community discussion > Static 1to1 NAT on cEdge - Cisco Community. The working cEdge is on 17.3.1a with externally accessible services ...
Is there a way to start/stop recording from a meeting room in a dual homed meeting. Currently, I can start/stop from within Cisco Meeting Manager but would like the meeting organizers to be able to do this at the touch panels. I assume since this i...
Nice. Looks like they released a 7.2.7 yesterday as well. Not sure I'm ready to make that jump to 7.4.1 but we could always try it at one of our branches first.
Any luck here? We are pretty much in the same boat. I've never been able to get the ZBFW working with the HA scenario and just route up to an ASA. I haven't tested on the later releases nor have I seen any type of documentation detailing how to ac...
In case anyone else runs into this, the functionality was brought back in 17.6.2 (Possibly 17.6.1a). It requires a ZBFW Rule with Outside > Service VPN zone pair as well as the Static NAT config on the VPN 0 (Outside) Cisco VPN Interface Ethernet. ...
