Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guyshere is my scenario: i want using FTD device as a rate limiting box only, by using FTD QoS feature and network rule condition by defining 5 or 6 IP address subnet (x.x.x.0/24) and limit them to specific download speed.if a i add a blocks of ip...
hello guysi setup a vPC scenario as shown in the picture. server 1.1.1.100 can ping 1.1.1.120 and 130 and vice versa. the link failover or switch failed will work fine.but server in vPC switch ( here is server 1.1.1.100) can not ping 1.1.1.1 (3164-A)...
hello every bodyi try to configure syslog client on my cisco 3064 nexus switch by this command #logging server 192.168.3.250 5 use-vrf management facility syslog#logging monitor 6bu nothing is send to my syslog server.i have 5 more 2960 and they are ...
hi @MHM Cisco World in my case, i create a QoS rule that in network condition i insert 192.168.0.0/24 in source section, with download rate limitation 30Mb. now my question is, if my clients in 192.168.0.0/24 range start to using internet at a Sameti...
thanks @Sergiu.Daniluk after a lot search i can solve my problem by one of these work round :1- use HSRP for correcting my L3 problem by keeping this topology.2- remove 1.1.1.1 from 3164-A and assing 1.1.1.1 to a other device like new router or firew...
more details i enabling Peer-gateway on both 3164. arp status on my client :1.1.1.1 28-AC-9E-A8-38-31 Reachable ActiveStore3164-A: show mac address-table G - 28ac.9ea8.3831 static - F F sup-eth1(R)G 1 28ac.9ea8.3831 static - F F sup-eth1(R)3164-B: sh...
