Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am Connecting to a new Centurylink IA service. My handoff is from an AdTran router. I have a basic config on my firewall with NAT. My speed is very slowbut port interface counters are clean. Provider is insisting they don't see ARP from me. Is...
applied an iOS update to a stack via tftp. I used the archive Download-sw tftp:// method. I rebooted the stack after complete and it never came back up. I discovered the master switch upgraded but not the member. The member was sitting there with ...
just got new hardware and decided to try the newer USB port for IOS upgrades. I could not get the switch to recognize my 2gig flash drive. Do I need a proprietary stick or special format?I also noticed when I removed it the switches crash dump and ...
I'm hanging up new 1262 APs in a new construction manufacturing environment. Not a lot of steel shelving just rows of workstations and machines. I can mount off ceiling red iron I-beams with a custom mount extension to cut down on signal bounce. T...
This is my first use of 50u single mode fiber. Prior we only had 62.5u multimode. I've got 3750x switches and new SM SFP and yellow fiber patch cables. None of my links show connected. No lights and trunk port interfaces show down/down.Is there a...
Guess I was assuming the SFP would do the crossover automatically, like MDIX on a port. Does a MM SFP do this but not SM?Sent from Cisco Technical Support iPad App
I am also planning a W2008 R2 schema update and need to verify if my ACS is compatible. I have two redundant ACS solution engines at this version.Release 4.2(0) Build 124 Patch 17
