Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,Currently i am extend existing network. sometimes, the uplink is down from access switch (meraki MS250-48FP) to core switch (catalyst 4503-E). the core switch is running HSRP and access switch is stacking. When the uplink down, i can see on t...
i am running 1832i ap and join to existing controller. trying to configure snmp but cannot do "config t" even after put the command "debug capwap console cli". Is there any workaround in order for me to push the config since previously AP which is 17...
Hi All,
I have 1 unit 3850-12XS (3.07.04E). Trying to configure the speed at the port since the end device connect to media converter. Is there anything that need to be done?
Hello,
recently got 1852i wireless access points. The AP being configured as WLC, is it any way to hide the SSID once we create it? since there are no option to hide it?
Noted. But if i configure 4503 to be the primary and secondary roots for spanning tree without convert existing spanning-tree from pvst to mst should be no issue right?
Sorry, just now just realize the command " channel-protocol lacp" in catalyst can be issue without command "channel-group X mode on/active" to the interface.Previously i cannot use LACP because 4503 is just running HSRP without VSS.Will configure LAC...
Hi Philip,Thanks, i will check on the release noted before upgrade to 10.x firmware.The Uplink have 2 cable between Meraki MS and 4503. In the 4503, did not configure root for the spanning tree.HSRP is between 2unit of 4503. Other device that plug to...
Hi Philip,Thanks. Is there any workaround without reconfigure my 4503 from pvst to mst?The link between this device is Gigabit Fiber.on the 4503 is one ip address is looping and hsrp keep changing from active to standby. until i shutdown one of the u...
