SNMP in 1830 Series

[khairul.farhan]

i am running 1832i ap and join to existing controller. trying to configure snmp but cannot do "config t" even after put the command "debug capwap console cli". Is there any workaround in order for me to push the config since previously AP which is 1702 can do.

[Rasika Nayanajith · Accepted solution]

You should be able to get AP related info from WLC. 

It is not necessary to configure SNMP on AP itself, even you configure those won't be retain after a power cycle.

1800/2800/3800 AP are different to previous generations, so commands you do on them may not work with this new generation APs

HTH

Rasika

*** Pls rate all useful responses ***