Mobility Express

[khairul.farhan]

Hello,

recently got 1852i wireless access points. The AP being configured as WLC, is it any way to hide the SSID once we create it? since there are no option to hide it?

[Sandeep Choudhary]

Hi farhan,

I am not sure if GUI option is available for it or not but you can do it via CLI:

From the CLI is the following command available:

config wlan broadcast-ssid disable <wlan id> where wlan id is the number of your wlan. If unsure of that, do a show wlan summary which should give you that info.

Regards

Dont forget to rate helpful posts

[khairul.farhan]

Hi Sandeep,

If i do "config wlan broadcast-ssid disable <wlan id>" it will stop the broadcast ssid. Just want to hide it only.

[Sandeep Choudhary · Accepted solution]

it will just hide the ssid.

Regards

Dont forget to rate helpful posts

[khairul.farhan]

Hi Sandeep,

When i issue the command, SSID disable and i cannot connect to the WLAN. It just disable it instead hide.

[Sandeep Choudhary]

paste the output of this command:

sh wlan summary

Regards

[khairul.farhan]

it just show 2 wlan only. can find the attachment.

Thanks

[Sandeep Choudhary]

Bro,

It will disable the ssid.

paste the output of above command: sh wlan <1 or 2>

Regards

[khairul.farhan]

ok, it shows it disable the ssid.

[Sandeep Choudhary]

see the output of the command:

Status is enabled

and Broadcast SSID is disabled..

Thats correct!!!!!!!

Regards

Dont forget to rate all helpful posts