About w.siewert

w.siewert · 02-01-2010

recommended server for DCNM 4.2 is Microsoft Windows Server 2003 Enterprise edition Service Pack 1. Is there a newer version of DCNM on the road map which can be installed on Windows Server 2008? Are there any known details regarding this issue?thx i...

w.siewert · 10-07-2008

Hi All,what please is the difference between a layer 3 switch and a router?Is it more safe to use a router than a layer 3 switch? In general, when overloaded, a router drops packets, a switch forwards all packets to all ports... or a router without c...

w.siewert · 05-14-2008

Hi,I have cat4500 with several vlans:10.1.x.x172.23.1.x172.23.2.x172.23.3.xI have configured RIP and 172.23.0.0 is propagated. Can sombody please tell me how to configure RIP that the subnets 172.23.1.x, 172.23.2.x and 172.23.3.x are propagated.curre...

w.siewert · 10-09-2008

Dear All,thanks a lot for your help and sharing your knowledge & experience with all of us!best regards from good old Germany Werner

w.siewert · 10-07-2008

it depends on configuration, if configured as routed port broadcasts are terminated, if configured as switchport broadcasts are forwarded!Werner

w.siewert · 10-07-2008

if you look here, you can get even new BNC-RJ45 converters:http://www.blackbox.com/Catalog/Detail.aspx?cid=308,1416,1499&mid=558Werner

w.siewert · 05-14-2008

If you use MS network load balancing ? be careful. MS uses Multicast MAC-Addresses to reach the Servers, therefore you don't need etherchannel, the packets are flooded over the network... this will cause problems if you have a bigger layer 2 network.

w.siewert · 05-03-2002

We have a cisco 2820 Ethernet Switch with 1 FastEthernet Module and 1 FDDI Module. Through this switch we have the link from our FDDI Backbone to the Gigabit Ethernet Backbone.

Member Since	‎06-11-2001 08:12 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	8
Total Helpful Votes Received	4

User Statistics

User Activity

DCNM and recommended server???

Layer 3 switch or Router

Problem with RIP Configuration

Re: Layer 3 switch or Router

Re: Layer 3 Switches

Re: Switch - BNC and RJ45

Re: Etherchannel with 2 different switches

Re: What device provides the best solution to Convert FDDI to Et