Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having an issue with Campus manager where Data Collection only runs after a daemon restart, but fails to run consecutive times. I've opened a TAC case and according to them, if you have Access Points on your network, this will cause Data Collecti...
When I run this report on one or any number of devices, the report has all zero's. However, if I run a 24hour report, there is obvious data. Thoughts?We're running LMS3.1, Windows ver, ACS integrated.
Is there a way to run a report that would generate subnet's discovered and cross reference that either the VTP domain or switch cloud? I'm assuming the application that would be able to generate such a report would be Campus Manager, but I can't figu...
I've been trying to build a custom report that shows the information contained in "Detailed Device Report" > Processor Port Interfaces > Port DescriptionThis shows which port has what type of GBIC installed, but I cannot find an attribute in the Cust...
We're in the process of migrating a site from one big flat network to vlans and were wondering how many secondary IPs an interface can have. All that I find online is "multiple". We might need 20-30... TIA
I'm running into a similar situation:We upgraded from LMS3.1 to 3.2 and noticed that CM looked like it was completely empty. ANI reinitialize during upgrade?After noticing this, we ran a Device Collection which appeared to have run properly, then a U...
I should have also mentioned that the report did produce data as of about a week ago, but has suddenly stopped. We have a daily syslog report that emails out events etc. We have quite a few reports from both the standard set and our customized ones. ...
