Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I bought new Cisco4506E series chassis and I am going to use below mentioned blades.1.) 3 4148-RJ bladesI am having a circuit of 15-Amp/120Volts, Will it powe ron the chassis with above mentioned blades?Mahi
Hi All,I need to ask 2 questions regarding 4506E series Chassis.1.) Is it possible to order a 5-15R power receptacle for Cisco4506E series chassis?2.) Can we power on Cisco4506E series chassis with 15-Amp current/120 Volt? Please let me know, if furt...
HI,We are getting a lot of LCV and PCV errors on our 2650XM router. Vendor has checked the cabling and our cables also has been checked for errors but everything seems to be fine.We are running IOS code-12.3(13a) on our router.Interface configuratio...
HiWe need to build a wireless bridge between two sites. Do we need to pay periodic cost to some vendor like we pay for private line for ex:- To block some frequescy to send our data
Hi buddy,Thanks for the reply but I need to know the relation between voltage and amperage. As we have 120Volt/15 Amp circuit but specification says it needs 100Volts/16Amp, Will it work?
Hi Buddy,Thanks for the reply.Can you please help me in calculating power requirements for 4506-E series with 1300 Watts redundant power supply mode.Modules used in the Chassis1.) WS-X4148-RJ - 3 Blades2.) WS-X4548-GB-RJ45 - 1 bladeInput Power:- 120V...
We have tested the controller card as well as cabling on our side, vendor also tested teh circuit from thier side and they updated that theyare running clean too.We are not sure, where the problem lies now.
HI Rvr,There is a option in multilink to set the minimum links required to keep the multilink bundle up. You can set the minimum value to 1 so that if one link goes down, it will not affect the multilink bundle connectivity.ppp multilink min-link 1Pl...
